FAQ

• Conveyor maintenance and maintenance

  The luricating oil of the decelerating motor should be changed regularly according to its Operation Manual.2. The roller bearings and bearings every six months once a cleaning, and re-filled lithium-based Grease ZL-2. 3. The screw of tensioning device is coated with lithium base grease zy-2 every 3

  FAQ January 16, 2020
• Conveyor attention to matters

  conveyor should be responsible for the operation of a person. Carry out routine maintenance and repair after each shift: 1. Check whether the fasteners are loose. 2.The rubber scraper of each sweeper and material guide groove should be adjusted when it is worn. If the wear is serious, it should be r

  FAQ January 14, 2020
• Troubleshooting of Filter Press

  Troubleshooting of Filter Press 1. Conveyor belt skidding, the reason is the conveyor belt tension or driving drum surface sticky materials or moisture. The tension screw should be screwed to increase the tension. Clean the driving drum and increase the cleaning force of the empty section sweeper.2.

  FAQ January 09, 2020
• Filter cake washing way 

  filter cake needs to be washed, there are open flow one-way washing and two-way washing, underflow one-way washing and two-way washing. 1. open-flow one-way washing is, wash liquid from the thrust plate wash liquid into the hole in turn, through the filter cloth and then through the filter cake, fro

  FAQ January 07, 2020
• Composition of filter press

  a filter cloth on both sides. The base plate of the diaphragm plate is covered with rubber diaphragm on both sides, the outside of the diaphragm is covered with filter cloth, the side plate is the ordinary filter plate. When the material enters each filter chamber from the feed hole on the thrust pl

  FAQ December 26, 2019
• About sewage treatment

  To incomplete statistics, China's printing and dyeing wastewater discharge accounts for about 40% of the total industrial wastewater discharge, reaching 4106-5106 M3 / D, and discharges more than 950 million tons of wastewater every year The printing and dyeing wastewater is a kind of industrial was

  FAQ December 05, 2019
• Application of vacuum filter screen

  Mine dressing mud water pressure filter equipment coal mud centralized treatment equipment advantages: The whole machine frame adopts high strength steel welding structure. High strength and stable structure, enough to support the strong pressure caused by filter press feed long service life. Filte

  FAQ November 28, 2019
• The problems and causes in the use of paper-making forming fabris

  polyester forming fabrics

  FAQ November 19, 2019
• The preparation of the filter cloth before the filter press works

  (1) adjust the air pressure to set the tension of the filter cloth. During the pre-adjustment, pay attention that the tension telescopic frame can not touch the frame .(2) move the filter cloth offset sensing device slightly by hand Check if the cylinder will work properly. In addition, test whether

  FAQ November 14, 2019
• Installation and Use of Filter Cloths

  Since the filter press itself is of the same specification, the different filtration accuracy, speed, etc. required for different filtering objects are all achieved by using different filter filter cloth, also known as filter filter bag, and each filter filter. The filter board is wrapped with a fil

  FAQ November 05, 2019